dumptruck

KO | EN

gitlite — search

#react #llm #golang #go #machine-learning #deep-learning #linux #docker #java #nodejs #cli #awesome-list #pytorch #security

(★ 17)

FPGA based dumper for flashes and more

dumptruck Latest Version Download

Download Latest Version (.zip)

// repository documentation

Was this content helpful?

★ 0 (0 ratings)

# dumptruck
FPGA based dumper for flashes and more

## Main PCB errata

Bugs in the v0.1 PCB

* 1.0V shunt resistor is missing a zone fill. Will monitor droop under load and see if we need to add top layer power path.
* U33 is way too close to J10. Seems to have fit OK, not touching for now, but tough to assemble.
* INIT_B and PROG_B on FPGA are 1.8V signals but we try to drive with 3.3 from supervisor! Rework: add pull to 1.8V on board, open drain in super firmware
* JTAG connector VCC is connected to 3.3V. We need to supply 1.8 here. Temporary workaround: six pin extension cable, pass through JTAG + GND and supply 1.8V to dongle externally. Long term fix: interposer board
* DONE on FPGA is 1.8V signal driving 3.3V input on supervisor, too low for Vih. Rework: add 1.8V gate drive NMOS to pull low when done, invert logic in firmware

TODO: add HF caps to VCAP on STM32

## Breakout board errata

* v0.1 of parallel-nor-csp56 and dip8-qspi had EEPROM at 0xa0 which conflicted with MAC address EEPROM. Future breakouts use 0xa2 to avoid conflict

dumptruck

dumptruck Latest Version Download

Today's picks

Was this content helpful?

Recent Feedback

dumptruck

dumptruck Latest Version Download

Today's picks

Was this content helpful?

Recent Feedback

Download README