SHT30

KO | EN

gitlite — search

#python #java #python3 #arduino #golang #machine-learning #rust #html #flask #javascript #seismology #nodejs

★ 26 Open GitHub ↗

SHT30 Humidity and Temperature Sensor

// repository documentation

Was this content helpful?

★ 0 (0 ratings)

# SHT3x
## Arduino library for Sensirion temperature and humidity sensors SHT30, SHT31 & SHT35.
The heavy version.  
Check for /examples for examples of different use cases.

The datasheet I followed is:  
https://www.sensirion.com/fileadmin/user_upload/customers/sensirion/Dokumente/2_Humidity_Sensors/Sensirion_Humidity_Sensors_SHT3x_Datasheet_digital.pdf  
For more simple version check the SimpleSHT3x library.

The constructor structure:  
SHT3x(    int Address = 0x44, //I2C device address, 0x44 or 0x45  
        ValueIfError Value = Zero, //What to return in case of errors. Zero or PrevValue  
        uint8_t HardResetPin = 255, //Number of pin RESET connected to (input from 100 to 255 if not used)  
        SHT3xSensor SensorType = SHT30, //Sensor type, SHT30, SHT31 or SHT35.  
        SHT3xMode Mode=Single_HighRep_ClockStretch //Operation mode , look for "enum SHT3xMode"  
);

Do not forget about the UpdateData() method: this method polls sensors.

### Supports:  
    Temperature data at Celsius, Kelvin and Fahrenheit scales.  
    Relative humidity data.  
    Absolute humidity data at Torr, mm Hg, Pa, bar, technical and standard atmosphere, psi scales.  
    Data integrity (by CRC8 algorithm) (datasheet/section 4.12).  
    Temperature, relative and absolute humidity tolerances (in dependence from measured values)  
    Calibration (linear) of temperature and humidity data by factors or by reverse sensor values (2 points)  
    Heater On/Off (integrated to SHT3x sensor) (datasheet/section 4.10)  
    Different sensor actions modes (datasheet/section 4.3)  
    Reset: soft (I2C) and hard (by corresponding pin) (datasheet/section 4.9)  
    
### Do not supports:  
    Action in periodic mode (datasheet/section 4.5)  
    Interrupts (datasheet/section 3.5)  
    
    
    
Note 1: by default, the data from sensor updates not faster, than 2 times a second.
For faster update use SetUpdateInterval(uint32_t UpdateIntervalMillisec); but do not exceed the datasheet values (10 measurments per second (100 ms)) because of sensor self-heating (datasheet/section 4.5, at the end of Table 9)

Note 2: The sensor type affects the tolerance values only.

Created by Risele for everyone's use (profit and non-profit).

ALL THESE WOR_DS  
ARE YOURS EXCEPT  
RISELE  
ATTEMPT NO  
namechangING THERE  
USE THEM TOGETHER  
USE THEM IN PEACE

SHT30

Explore Similar Repositories

Was this content helpful?

Recent Feedback

Download README