STM32F0_minimal_C

KO | EN

gitlite — search

#hacktoberfest #ai #llm #go #android #machine-learning #rust #deep-learning #linux #nodejs #awesome #kubernetes #mcp #open-source

STM32F0_minimal_C

(★ 30)

Minimal code required to boot an STM32F0 chip into a C 'main' method.

STM32F0_minimal_C 최신버젼 다운로드

최종 버전 다운로드 (.zip)

// repository documentation

Was this content helpful?

★ 0 (0 ratings)

# Overview

This is a project with some minimal code for booting a program on an STM32F031K6 chip.

A Makefile is provided, and I've tested the program with a 'Nucleo-32' board with the STM32F031K6 chip. To upload the resulting program, you can use your choice of uploader/debugger. I use GDB and Texane's "stlink" project:

https://github.com/texane/stlink

It's a fairly simple process to upload and debug a program:

0. Run `make` in the project directory to build the project.

1. Plug your board in - for ST's Nucleo boards, you can just use an ordinary micro-USB cable.

2. Enter `st-util` in a terminal window after installing the utilities linked above. You should see some general information printed about your chip.

3. Run `arm-none-eabi-gdb main.elf` (or whatever your file is called, if it's not 'main.elf')

4. Point GDB to the port opened by 'st-util' - usually 4242 - with the command: `target extended-remote :4242`

5. Enter `load` to upload your program.

6. You're code is uploaded! Enter `continue` to start it running, and hit `ctrl+C` a few times (maybe followed by 'y' for 'yes') to interrupt it once it's started.

Once the code is uploaded, you can more or less treat the GDB debugging session like you would any other C/C++ program. You can set breakpoints, step through the code with `s`/`si`/`n`/`ni`/etc, inspect variables or memory addresses, and so on.

STM32F0_minimal_C

STM32F0_minimal_C 최신버젼 다운로드

오늘의 추천 프로젝트

Was this content helpful?

Recent Feedback

STM32F0_minimal_C

STM32F0_minimal_C 최신버젼 다운로드

오늘의 추천 프로젝트

Was this content helpful?

Recent Feedback

Download README