NetEraser

KO | EN

gitlite — search

#python #react #llm #golang #rust #deep-learning #macos #windows #awesome #awesome-list #vue #security #ios #mcp

(★ 23)

A tool that deauthenticates 2.4GHz and 5GHz Wi-Fi networks using BW16.

NetEraser Latest Version Download

Download Latest Version (.zip)

// repository documentation

Was this content helpful?

★ 0 (0 ratings)

# NetEraser
A tool that deauthenticates 2.4GHz and 5GHz Wi-Fi networks using BW16.

# Key Features
- Minimal Setup.
- Simple Interface.
- It deauthenticates 2.4GHz and 5GHz WiFi networks both.

# Hardware Requirements
- Ai-Thinker BW16 RTL8720DN Development Board

# Note
- It has two variants : Type-B and Type-C connectors.

# Setup
1. Download Arduino IDE from [here](https://www.arduino.cc/en/software) according to your Operating System.
2. Install it.
3. Go to `File` → `Preferences` → `Additional Boards Manager URLs`.
4. Paste the following link :
   
   ```
   https://github.com/ambiot/ambd_arduino/raw/master/Arduino_package/package_realtek_amebad_index.json
   ```
5. Click on `OK`.
6. Go to `Tools` → `Board` → `Board Manager`.
7. Wait for sometimes and search `Realtek Ameba Boards (32-Bits ARM Cortex-M33@200MHz)` by `Realtek`.
8. Simply install version `3.1.7`.
9. Restart the Arduino IDE by closing and open again.
10. Done!

# Install
1. Download or Clone the Repository.
2. Open the folder and just double click on `NetEraser.ino` file.
   - It opens in Arduino IDE.
3. Compile the code.
4. Select the correct board from the `Tools` → `Board` → `AmebaD ARM (32-bits) Boards`.
   - It is `Ai-Thinker BW16 (RTL8720DN)`.
6. Select the correct port number of that board.
7. Go to `Tools` → `Board` → `Auto Flash Mode` and select `Enable`.
8. Upload the code.
   - Wait for sometime, the `GREEN` led turns ON.

# Run the Script
1. After uploading wait 1-2 minutes and after that an Access Point is created named `NetEraser` whose password is `neteraser`.
2. Connect to it.
3. Open any browser and type the following IP : `192.168.4.1`.
4. Select the network want to deauth by click on the radio button.
5. After that, click on `Start` button.
   - The Red led start flickering means it deauthenticates that network.

# Note
- Sometimes, it can't deauth at starting.
- So go back to main page and click on `Start` button.

# Indicators
- 🟢 - The BW16 board is ready to deauth.
- 🔴 - The BW16 board is sending deauthentication frames.

NetEraser

NetEraser Latest Version Download

Today's picks

Was this content helpful?

Recent Feedback

NetEraser

NetEraser Latest Version Download

Today's picks

Was this content helpful?

Recent Feedback

Download README