esp32-zigbee-presence

KO | EN

gitlite — search

#python #hacktoberfest #react #ai #llm #machine-learning #deep-learning #docker #macos #awesome #cli #kubernetes #awesome-list #pytorch

esp32-zigbee-presence

(★ 9)

ESP32-C6 (H2?) seeed xiao based zigbee presence detector/

esp32-zigbee-presence 최신버젼 다운로드

최종 버전 다운로드 (.zip)

// repository documentation

Was this content helpful?

★ 0 (0 ratings)

# XIAO ESP32-C6 mmWave Presence Sensor

Zigbee-enabled presence detection sensor using Seeed Studio XIAO hardware, compatible with Home Assistant and other Zigbee 3.0 ecosystems.

![3D Enclosure Preview](https://raw.githubusercontent.com/vggscqq/esp32-zigbee-presence/main/photos/enclosure_preview.png) ![IRL Enclosure Preview](https://raw.githubusercontent.com/vggscqq/esp32-zigbee-presence/main/photos/enclosure_preview_exploided.png)
![HomeAssistant Preview](https://raw.githubusercontent.com/vggscqq/esp32-zigbee-presence/main/photos/ha.png)

## 📖 Project Overview

This project combines:
- **[Seeed XIAO ESP32-C6](https://wiki.seeedstudio.com/xiao_esp32c6_getting_started/)** (Wi-Fi 6 + Bluetooth 5 + Zigbee 3.0 SoC)
- **[Seeed XIAO 24GHz mmWave Presence Sensor](https://wiki.seeedstudio.com/mmwave_for_xiao/)**
- Custom 3D-printed enclosure.
- Zigbee 3.0 compatible firmware.

**Key Features** 🌟
- 🏠 Home Assistant compatible out-of-the-box (Zigbee2MQTT/ ZHA).
- 🖨️ Enclosure designs ([STL files](/enclosure)).
- 📶 Supports Zigbee connectivity.

## 📦 Hardware Requirements
- Seeed Studio XIAO ESP32-C6
- Seeed Studio XIAO 24GHz mmWave Presence Sensor
- 3D printed enclosure ([STL files](/enclosure))
- A little bit of solder for soldering pins.
- One M3 bolt (6-10mm) and M3 nut.

## 🛠️ Installation

### 1. Firmware Setup
```bash
# Clone repository
git clone https://github.com/vggscqq/esp32-zigbee-presence.git
```

Change sensor's baud rate to **9600**.

When changing the sensor's baud rate using the Android app, the app will always display 256000 as the baud rate even after successfully changing it to a different value. This is a known UI issue in the app - the actual baud rate does get changed correctly despite what is shown in the interface.
Flash it with arduino ide. Make sure to select End Device Zigbee mode and Zigbee 4MB with spiffs partition scheme.

## Acknowledgments
* [https://github.com/FutureSharks](FutureSharks) for helping with sensor's baud rate bug.

esp32-zigbee-presence

esp32-zigbee-presence 최신버젼 다운로드

오늘의 추천 프로젝트

Was this content helpful?

Recent Feedback

esp32-zigbee-presence

esp32-zigbee-presence 최신버젼 다운로드

오늘의 추천 프로젝트

Was this content helpful?

Recent Feedback

Download README